Viv AutoPilot Bill Negotiator Overview

AutoPilot is Expanding Nationwide!

AutoPilot is bringing it’s saving power to more than just electricity costs with bill negotiating services for cable, internet, satellite, wireless and home security!

So what will this product enhancement mean for you? Let’s take a look.

Who do you know that pays for cable, satellite, internet, wireless or home security services?

Just about everyone pays for at least one of those services in America. In fact, most pay for three or more. But, did you know that Americans are overpaying more than $60 billion on these service every year? We saw this problem sweeping across the nation as an opportunity to help more people save nationwide.

Now not only will AutoPilot automatically switch you to the best energy rate plan to save you money, but you can save more on other essential services you use every day. Imagine how by lowering your cost of living expenses, you will gain more discretionary income to do more in your life like take a family vacation, save for college tuition, or just take more “me time.” The process is simple:

You upload your bills.

We lower your bills.

WHEN WILL THIS ALL GO INTO EFFECT?

You will be able to start submitting your bills the week of January 28! When this becomes available online, send your customers to the enrollment page of your personal website where they will see a variety of bill types to upload under the AutoPilot section. Plus, you will also be able to upload your bills directly from your Virtual Office under the Products & Services section.

Next, we will need 4-6 weeks to allow for our beta negotiations. We will begin doing these bill negotiations in batches, and then after our beta you will see the negotiations happening much faster. Qualified points during this time will count toward your commission eligibility.

Help people stop overpaying their bills

Why are Americans overpaying? Most of us just don’t realize that we are being overcharged and we don’t know that our bills for these types of services can be negotiated down.

Remove the hassle

Bill lowering categories

These are the services we are just getting started with. This list of services will continue to grow.

We help you save 4 ways

Managed Services and Negotiated Service are similar in that we are focused on your monthly bills for services you use every day. With Managed Services, we automatically monitor and select the right plan and provider for you and your customers—switching you on your behalf term after term and charging a low, fixed subscription cost based on the size of your home or business. We don’t start charging your subscription fee until we’ve found your first cost-savings plan. Currently we offer this for our core electricity service in 10 markets. Our Negotiated Services are available nationwide for homes and businesses for services like cable, internet, satellite, wireless or home security to start. You and your customers stay with your same provider and we are simply negotiating a lower bill for your exact same service! There’s no fee unless we save, and when we successfully save for you and your customer we split the savings with you.

Later in Q2 this year we will introduce Concierge Services for things you shop for like insurance. We will help you shop to find the lowest rate! Lastly we are in beta for Audit Services for large commercial customers. This is where we look back 3-4 years on services businesses have paid for already, yet they were over charged. We will work to audit different services, like energy and other utilities, that have been overpaid due to billing errors such as wrong rate class or worker’s compensation fees and recover the funds for them. If you have a large commercial customer interested in taking part of this beta, let us know by sending an email to support@justviv.com.

HERE'S A RECAP

You don't pay unless you save!

There is zero risk for your customer to see how much they can save. We don’t charge your customer unless they want to save where we split the savings with them. They can either pay 50% of their savings over the term of the savings period, or they can pay just 40% of the savings all up front when we finish the negotiation. It’s their choice.

Let’s take a look at an example:

How will this affect you as a Life Consultant?

Sharing is simple. This is a great conversation starter and leads to getting more people referred and interested in lowering their bill.

Here's how you get paid

Start by uploading just one bill and you earn 1 point for every qualified bill for at least 3 months or as long as you or your customer saves! You also earn on the Commissionable Volume every time a customer in your business saves.

Here's the process

It really is this simple!

© 2025 Viv | Products that make your life better. © 2019 Viv | Products that make your life better. Viv Network, LLC, proud member of the Path One Group of companies / Viv AutoPilot is provided through a partnership with Utiliz, LLC. Utiliz, LLC is licensed by CT PURA (dkt 16-10-04), IL ICC (reg 0661122-2), MA DPU (lic EB-459), MD PSC (IR-4067), NH PUC (dkt DM 17-092), NJ BPU (reg EA-0447) OH PUCO (crt 18-1328E(1)) & RI PUC (reg 1687000) | *Estimated savings are based on historical average across all customers. Savings vary depending on region and market dynamics. Your actual savings may be higher or lower than any examples or estimates shown, but your satisfaction is guaranteed.

IntelliPTAC was developed for PTAC HVAC systems as an extension of the IntelliHVAC technology.

IntelliPTAC retrofits to the controls of PTAC units and has two functions: The 1st is an intelligent variable post purge and the 2nd is the intelligent compressor cycling function.

The Intelligent Variable Post Purge monitors the PTAC system and adjusts the length of post purge timing based on the previous compressor cycle. This ensures that we capture all of the energy that has been created and get it into the building so that it hasn’t been wasted.The Intelligent Compressor Cycling Function turns the compressor off for 3 minutes every time it runs for 18 minutes continuously and runs the post purge fan for that same length of time instead. The reason this works is because after 18 minutes of continuous run-time, the cool is fully energized which is to say that the cup is full. It is holding all the energy is can hold but is continuing to run because the thermostat is telling it to and doesn’t know any better.All of this translates into energy savings of 10-15% or approximately $300 per PTAC unit per year. IntelliPTAC is simple to install, requires no maintenance, has a 3-year warranty and a 12-18 month ROI.

Anti-Sweat Heater Door Control (ASH-DC)

ASH-DC was developed to remedy a basic design flaw in glass cooler and freezer doors such as those in convenience stores, liquor stores and grocery stores. These doors have heaters on them that run 24 hours a day to ensure that the glass remains free of frost and condensation. The reality is that these heaters do not need to run constantly, and a lot of energy is being wasted.

ASH-DC retrofits to the door system (typically a group of four doors) and utilizes a digital moisture sensor to activate the anti-sweat heaters only when the threat of moisture is present.

ASH-DC also utilizes a Programmed Maintenance Cycle that activates the heaters on regular intervals — 15 minutes every three hours — to ensure that all parts of the cooler or freezer system remain frost free.

The maintenance cycle has been engineered with “random start” technology, so the heater will cycle at different times on different cases, even if there is a loss of power.

All of this translates into energy savings of 80%-85% or approximately $1,000 per door set per year. ASH-DC is simple to install, requires no maintenance, has a three-year warranty and a typical 12-month ROI.

Applies to glass door sets of coolers and freezers
Retrofits to existing system
Provides more efficient use of door heater systems
Sensor-based technology reads moisture levels and controls heaters accordingly
Eliminates unnecessary heater run time and energy use
Reduces energy consumption 80%-85% on average
Approximately $1,000 per year in savings
No additional maintenance required
Three-year warranty
12-month ROI or lease option

EnerG² was developed to eliminate excess energy consumption in walk-in coolers and freezers. Thermometers in these walk-ins measure ambient air temperature, which fluctuates much more than the temperature of the actual food.

EnerG² contains a specialized gel compound that stimulates food product temperature instead of ambient air temperature. It retrofits to the existing thermostat air probe and provides a more accurate measurement, eliminating unnecessary compressor cycles and run time. This translates into average energy savings of 15%-25% and maintenance savings of 40%-60% or about $600 per walk-in per year. EnerG² is easy to install, requires no maintenance, has a lifetime warranty and an average ROI of 12 months.

Applies to walk-in coolers and freezers
Retrofits to existing thermostat
Provides more accurate temperature measurement
Specialized gel compound simulates food product temperature instead of ambient air temperature
Eliminates unnecessary compressor cycles and run time
Reduces energy consumption 15%-25% on average
Reduces maintenance costs by 40%-60% on average
Approximately $500-$700 per year in savings
No additional maintenance required
Lifetime warranty
12-month ROI or lease option

IntelliHVAC was developed based on a utility study (PG&E) that found that HVAC systems lose approximately 30% of the energy they create. The reason is that the manufacturers’ post-purge setting often does not run long enough to capture and use all of the energy that was created by the unit during the run cycle. That latent energy then dissipates and is lost.

IntelliHVAC retrofits to the 24-volt terminal of package and split HVAC units and has two functions: an Intelligent Variable Post Purge and the Intelligent Compressor Cycling Function.

The Intelligent Variable Post Purge monitors the HVAC system and adjusts the length of the post-purge cycle based on the previous compressor cycle. It optimizes the time the fan runs, enabling the unit to capture all of the energy that was created so that it isn’t wasted.

The Intelligent Compressor Cycling Function turns the compressor off for 5 minutes of every 25-minute cycle, running the post-purge fan during that 5 minutes. The fan captures the latent energy and continues to circulate the air, reducing the energy use — and the cost. This works because, after 25 minutes, the system is fully energized, which is to say that the cup is full. It is holding all the energy it can hold but is continuing to run because it doesn’t know any better.

All of this translates into energy savings of 10%-30% or approximately $1,500 per HVAC unit per year. IntelliHVAC is simple to install, requires no maintenance, has a lifetime warranty and an average ROI of 12 months.

Applies to package and split system HVAC units
Retrofits to 24V terminal
Two functions:
- Intelligent Variable Post Purge: Variable timing fan control on post-purge fan based on previous compressor cycles and run time. All the fan you need, none of what you don’t.
- Intelligent Compressor Cycle Function: Turns compressor off after 25 minutes of continuous run time, running the fan instead to allow the system to capture the energy already created.
Reduces energy consumption 10%-30% on average
Reduces maintenance costs by 15% on average
No additional maintenance required
Lifetime warranty
12-month ROI or lease option
Approximately $1,000-$1,500 per year in savings